<VV> VV Posts -- Lakewood tech question

[shortle]

My '62 Monza Wagon has large chrome headed phillips sheet metal screws .
Timothy Shortle in Durango Colorado


-----Original Message-----
>From: Bryan Blackwell <bryan at skiblack.com>
>Sent: Feb 21, 2011 7:46 PM
>To: Chris & Bill Strickland <lechevrier at earthlink.net>
>Cc: virtualvairs at corvair.org
>Subject: Re: <VV> VV Posts -- Lakewood tech question
>
>Hi Bill,
>
>You asked this a while ago, but I didn't get a chance to look at all until yesterday.  On the '61 shell, there are the little clips with machine thread nuts on the back.  I'm pretty sure the screws are similar to the ones that hold the battery cover, a chrome button head, but I don't know what sort of drive they are (Phillips, slotted, etc.).  Hope that helps.
>
>--Bryan
>
>On Dec 27, 2010, at 1:58 PM, Chris & Bill Strickland wrote:
>
>> What style of fastener was used on the rear edge of the Lakewood engine 
>> hatch cover -- were they machine or sheet metal screws and most 
>> important, what was the head design and finish?
>
> _______________________________________________
>This message was sent by the VirtualVairs mailing list, all copyrights are the property
>of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
>This list sponsored by the Corvair Society of America, http://www.corvair.org/
>Post messages to: VirtualVairs at corvair.org
>Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs 
> _______________________________________________