<VV> Resistor wire or not?

[corvairs at pacifier.com]

It's also the wire with the white cloth covering.

Lon
www.corvairunderground.com


> It's inside the engine wiring harness. Cream colored wire with a red
> (brown)
> tracer, if I remember.
> This wire is at the third pin at the engine/body connector, and goes to
> the
> yellow/blk (or blk/yel) lead on the starter two pin connector. Short the
> two
> to bypass the resistance wire.
>
> -----Original Message-----
> From: virtualvairs-bounces at corvair.org
> [mailto:virtualvairs-bounces at corvair.org] On Behalf Of Grant Young
> Sent: Sunday, August 28, 2011 2:59 PM
> To: virtualvairs at corvair.org
> Subject: <VV> Resistor wire or not?
>
> I am installing a Petronix ignition kit into a 1965 140 convertible. The
> instructions mention the option of leaving or removing the resistor or
> wire
> (for better performance), if there is one. So, is there one, and if so,
> where is it?
> Thanks,
> Grant
>  _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are
> the property
> of the writer, please attribute properly. For help,
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America,
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options:
> http://www.vv.corvair.org/mailman/options/virtualvairs
>  _______________________________________________
>
>  _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are
> the property
> of the writer, please attribute properly. For help,
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America,
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options:
> http://www.vv.corvair.org/mailman/options/virtualvairs
>  _______________________________________________
>
>