<VV> Turning over starter without the key (LM)

[Harry Yarnell]

Picture isn't REAL clear, but the two wire connector goes to the starter.
Stick a nail (6-8 penny) in the shell parallel to the purple wire, and clip
lead this to the 12 volt post on the battery. Either side of the connector
will work, just as long as it's the purple wire.

-----Original Message-----
From: virtualvairs-bounces at corvair.org
[mailto:virtualvairs-bounces at corvair.org] On Behalf Of Karl Haakonsen
Sent: Saturday, September 18, 2010 3:57 PM
To: virtualvairs at corvair.org
Subject: <VV> Turning over starter without the key (LM)

  Hi everyone,

I am told (thanks, Tom), that one can turn over the starter by applying 
12 volts to the purple wire that's part of a two-wire connector at the 
front portion of the engine compartment on the driver's side. Is it the 
purple wire circled in blue in this photo:

http://www.chezhawk.com/Corvair/PurpleWire.jpg

Is the two-wire connector the one at the bottom of the circle?

And if so, where do I apply the current? To the portion of the wire that 
goes up and forward, or the one that goes down?

Thanks!

Karl in Boston
 _______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are
the property
of the writer, please attribute properly. For help,
mailto:vv-help at corvair.org
This list sponsored by the Corvair Society of America,
http://www.corvair.org/
Post messages to: VirtualVairs at corvair.org
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs 
 _______________________________________________