<VV> Turning over starter without the key (LM)
Daniel Monasterio
dmonasterio at hotmail.com
Sat Sep 18 16:08:56 EDT 2010
Any end of that purple wire is ok to apply current (+12V), directly from the battery's positive post unless you dissconect the 2 wire-plug. If so, apply current to the purle wire that goes down (to the solenoid starter).
Daniel Monasterio
> Date: Sat, 18 Sep 2010 15:57:28 -0400
> From: cityhawk at pobox.com
> To: virtualvairs at corvair.org
> Subject: <VV> Turning over starter without the key (LM)
>
> Hi everyone,
>
> I am told (thanks, Tom), that one can turn over the starter by applying
> 12 volts to the purple wire that's part of a two-wire connector at the
> front portion of the engine compartment on the driver's side. Is it the
> purple wire circled in blue in this photo:
>
> http://www.chezhawk.com/Corvair/PurpleWire.jpg
>
> Is the two-wire connector the one at the bottom of the circle?
>
> And if so, where do I apply the current? To the portion of the wire that
> goes up and forward, or the one that goes down?
>
> Thanks!
>
> Karl in Boston
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are the property
> of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
> _______________________________________________
More information about the VirtualVairs
mailing list