<VV> NEW Fuel Pump Woes avoided

[J R Read]

Matt,

Sometimes you strip off too much!

Oh, I meant from the VV post to which you are responding.

What was the question to that answer?

You might wish to apply for the moderator job on - oh... which TV show is 
it?  You know, the one where you have to form your answer as a question. 
Goes like...

Q  The car that Ralph Nader had banned from the highways.

A  The Corvair.

Later, JR

PS:  About the stripping...
That was in reference to VV.  I have no personal knowledge, nor do I wish to 
of any other similar activity.

Everyone else - please at least have a mild grin now.

----- Original Message ----- 
From: "Matt Nall" <patiomatt at aol.com>
To: <virtualvairs at corvair.org>
Sent: Tuesday, September 07, 2010 12:05 AM
Subject: Re: <VV> NEW Fuel Pump Woes avoided


>
>
>  The general consensus in other forums, backed up by this months CC...
> 1  Dismantle new pumps and stake the 2 valves.
> 2  When tightening screws... place in vise to compress the spring/ pull 
> diaphragm to it's greatest stretch... Then tighten in a circle several 
> rotations..
>
>
>
>
> Matt Nall
> Charleston, Oregon
> http://mysite.ncnetwork.net/reswr0kp/
>
>
>
>
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are 
> the property
> of the writer, please attribute properly. For help, 
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: 
> http://www.vv.corvair.org/mailman/options/virtualvairs
> _______________________________________________