<VV> Removing strud rods on LM

[J R Read]

 Take them down from the diff end first.  Getting them off is easy compared
 to the installation.  If not a SHOW car, that takes a pipe wrench and two
 people.
 Later, JR

> ----- Original Message ----- 
> From: "Tom Gould" <tgould at hargray.com>
> To: <virtualvairs at corvair.org>
> Sent: Wednesday, September 01, 2010 11:23 AM
> Subject: <VV> Removing strud rods on LM
>
>
>> After much procrastination, I decide to tackle replacing the strut rods 
>> on my 66 with Clarks rebuilts. The nuts came off OK. But, the bolts do 
>> not want to budge. There isn't much rust on the nut end (car has not been 
>> street driven since 1976). Is there some trick or are we just talking 
>> lots of fluid and a bigger hammer?
>> _______________________________________________
>> This message was sent by the VirtualVairs mailing list, all copyrights 
>> are the property
>> of the writer, please attribute properly. For help, 
>> mailto:vv-help at corvair.org
>> This list sponsored by the Corvair Society of America, 
>> http://www.corvair.org/
>> Post messages to: VirtualVairs at corvair.org
>> Change your options: 
>> http://www.vv.corvair.org/mailman/options/virtualvairs
>> _______________________________________________
>