<VV> Corvair Engine #3 Journal Nicked

[ray smith]

You could  send it to a machine shop to have them fully inspect and prep it for you.



Ray Smith 


 
------Original Message------
From: Mark Durham
Sender: virtualvairs-bounces at corvair.org
To: Charles Lee
Cc: Virtual Vairs
Sent: Nov 18, 2010 1:45 PM
Subject: Re: <VV> Corvair Engine #3 Journal Nicked

No, it means "file it" in accordance with my instructions, gently drag
a fine flat file until bump is gone, if you made slight marks, polish
them out with something finer than 1000 grit, I use 1500, until gone,
then move on. Put it back together. Mark Durham

On Wed, Nov 17, 2010 at 9:54 PM, Charles Lee <Chaz at properproper.com> wrote:
> Does that mean "don't bother filing/sanding/smoothing/etc. it down" ?
>
> As Spence said (later) I can ignore it if it is not raised above the surface
>
> It is raised, so I need to shave it off, or it will tear into a new bearing
> ?
>
> PS: Isn't the rod 'bearing' actually a 'bushing' ?
>
> Charlie
>
>
>
>
 _______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are the property
of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
This list sponsored by the Corvair Society of America, http://www.corvair.org/
Post messages to: VirtualVairs at corvair.org
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs 
 _______________________________________________


Sent via BlackBerry by AT&T