<VV> timing mark jumps help

[Richard Gebhardt]

Shaun, does the timing change?  If no, it may be the outer ring slipping 
on the harmonic balancer
unless it has a solid HB.

Richard Gebhardt

 



S M wrote:
> Check the rollpin in the gear at the bottom of the distributor...
>
> ----- Original Message -----
> From: Vairdad at aol.com
> Date: Wednesday, March 24, 2010 12:01 pm
> Subject: <VV> timing mark jumps help
> To: virtualvairs at corvair.org
>
>   
>> 63 recently purchased. cleaned engine compartment rebuilt carbs, 
>> new plugs, 
>>  wires, points, dist. cap, rotor button, condensor. timing 
>> mark steady for 
>> a few  seconds then jumps about one inch then steady for 
>> few seconds then 
>> jumps again.  what is cause and how to fix problem. car not 
>> running when 
>> bought so not sure  how long problem. thanks for your help
>> garland
>>  _______________________________________________
>> This message was sent by the VirtualVairs mailing list, all 
>> copyrights are the property
>> of the writer, please attribute properly. For help, mailto:vv-
>> help at corvair.orgThis list sponsored by the Corvair Society of 
>> America, http://www.corvair.org/
>> Post messages to: VirtualVairs at corvair.org
>> Change your options: 
>> http://www.vv.corvair.org/mailman/options/virtualvairs 
>>  _______________________________________________
>>
>>     
>  _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are the property
> of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs 
>  _______________________________________________
>
>