<VV> Help! Ignition Messed UP

[Ron]

Don't work on your vehicle without the applicible shop manual!  The answers 
to your questions are all in the shop manual.
RonH

----- Original Message ----- 
From: "Bill H." <gojoe283 at yahoo.com>
To: <virtualvairs at corvair.org>
Sent: Monday, July 05, 2010 11:52 AM
Subject: <VV> Help! Ignition Messed UP


>                                     B"H
>
> Hi all...I'm in the middle of installing A/C in my car, and so far, 
> everything that can go wrong, has gone wrong!
>
> Now somehow I messed up my plug wires and ignition wires.  There is an 
> insulated "resistor" wire, that goes on one side of the coil.  Then I see 
> a yellowish-gold wire, it came loose from its terminal and I can't figure 
> out where this wire goes, but it looks like another ignition wire. 
> Doesn't that go on the coil also?
>
> Also, what's the best and easiest way to determine how to put the 
> distributor wires back correctly?  I have the firing order right, and I've 
> gotten the notch on the vibration damper pulley within the timing scale on 
> the block, but I've tried to put both #1 and #2 wires at the terinal where 
> the rotor's pointing.  The car backfires and almost starts, but won't.
>
> Help!  And thanks everyone.  Hope you're all having a great Forth!
>
> Bill Hershkowitz 69 Monza 110 PG
>
>
>
>
>
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are 
> the property
> of the writer, please attribute properly. For help, 
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: 
> http://www.vv.corvair.org/mailman/options/virtualvairs
> _______________________________________________