<VV> CHT GAGE

[scottygrover at aol.com]

Check out eMachineshop.com; they have  a table describing the physical  
characteristics of about any material  you'd find in a machine shop.
 
Scotty
 
 
In a message dated 1/15/2010 7:04:38 P.M. Pacific Standard Time,  
hmlinc at sbcglobal.net writes:

I think  the softening point must be about half that - based on some heads 
that  I've seen.

Later, JR


----- Original Message ----- 
From:  "Daniel Monasterio" <dmonasterio at hotmail.com>
To:  <hmlinc at sbcglobal.net>; <kovacsmj at sbcglobal.net>; "VirtualVairs"  
<virtualvairs at corvair.org>
Sent: Friday, January 15, 2010 7:01  PM
Subject: Re: <VV> CHT GAGE


Aluminium melts at 660°C  (1,220°F).


Daniel