<VV> FW: Engine issue

[Bill Bicknell]

I want to thank all those parties who responded to my below questions about the damage to my engine.  Your “virtual vairs” group did an outstanding job responding with several suggestions.  Business and some holiday travel this month will not allow me time to work on the engine for a while.  When things calm down after the first of the year, I’ll start checking out the suggestions given and be happy to report back my findings.

 

Thanks again and Happy Holidays to all members,

Bill Bicknell

 

_____________________________________________________________________________________________________

 


I have recently acquired a 1962 Rampside with #2 piston burned from what
appeared to be detonation.  All other pistons/cylinders looked normal.
After replacing the piston and honing the cylinder to clean up the aluminum
transfer, the same #2 piston became burned due to detonation.  The engine
would idle fine at 14 degree timing, but with lack of power.  At about 18
degree timing it seemed to run reasonably and with good power, but with
pinging noticeable when starting from a dead stop.  I have replaced the #2
piston again, this time with a different used cylinder  and still notice the
detonation from start, but haven't driven it much until I can learn more
about what's going on.

 

When I replaced the first piston, I also changed rings and bearings and
timed the camshaft to the crankshaft as accurately as I could determine.
This seemed to be a challenge.  I used keyway positions checking with
machine squares.  Since such advanced distributor timing is required, I am
still wondering if this is an issue.  What is the best technique for this
timing operation?  But why did the same cylinder position have the problem -
coincidence?

 

I have been rebuilding conventional water-cooled engines for decades, for a
while professionally, so I know engine basics but something is eluding me
here.  Perhaps something unique to Corvairs.  Knowing that
pre-ignition/detonation can initiate from carbon build up and/or sharp
edges, I wire brushed all combustion areas, valves, and valve cavities
clean prior to assembly.  All fins were cleaned to avoid hot spots.  The
sheet metal air deflectors are in place.  The thermostat properly opens the
air deflector valve when the engine heats up.

 

Can someone help with some suggestions?

 

Bill Bicknell

Home/office:573-364-8586

Cell phone: 970-218-1352

 

 _______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are the property
of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
This list sponsored by the Corvair Society of America, http://www.corvair.org/
Post messages to: VirtualVairs at corvair.org
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs 
 _______________________________________________