<VV> Corvair steering box lash adjust screw turns with locknut ?

[Charles Lee]

No, that's not the problem, but I see your point : there's no place to go if 
that was the case.

The lash screw has about 1/8" before it hits the locknut, but they move 
together because they're 'frozen' in lockstep (see other post immediately 
before this one)

Thanks for something good to know, hopefully in the distant future !
Charlie

----- Original Message ----- 
From: <HallGrenn at aol.com>
To: <virtualvairs at corvair.org>
Sent: Monday, August 23, 2010 7:07 PM
Subject: Re: <VV> Corvair steering box lash adjust screw turns with locknut 
?


>
> In a message dated 8/23/2010 9:32:42 P.M. Eastern Daylight Time,
> Chaz at ProperProper.com writes:
>
> I can't  adjust the screw any further than the locknut allows  (CW).
>
>
>
> Charlie,
>
> If you mean the lash adjuster is below the locknut then it is time for
> another steering box.  But you can remove them and replace them if 
> necessary.
>
> Bob Hall
> Group Corvair
> Corvanatics
> CORSA
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are 
> the property
> of the writer, please attribute properly. For help, 
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: 
> http://www.vv.corvair.org/mailman/options/virtualvairs
> _______________________________________________
>