<VV> coil wiring help needed
Charles Lee
Chaz at ProperProper.com
Mon Aug 2 03:33:34 EDT 2010
I am not certain if this diagram is specific enough for an early model 1963,
but it may help ?
If any VV'er can add whether or not it applies, or add to this, please chime
in !
If I can update this diagram, or make another that is more relevant to an
early model, please let me know that too ?
http://www.yourbuyersinn.com/Cars/Corvair/CorvairIgnitionWiring.htm
Thanks
chalice
----- Original Message -----
From: "Ray "Grymm" Rodriguez" <vairguy at echoes.net>
To: "corvair" <virtualvairs at corvair.org>
Sent: Monday, August 02, 2010 12:02 AM
Subject: <VV> coil wiring help needed
> Hey all,
>
> I'm trying to figure out the wiring for the coil on the 63'.... I dont
> have a 63' manual yet and since the wiring was tampered with at some point
> it's not self evident which wire goes where.
>
> First question: I believe this car should have an external resistor not a
> resistor wire.....I have a resistor for it but want to make sure it
> belongs in the circuit and that I have it connected to the right wire.
> Please confirm that I need one and which color wire it goes on.
>
> I have four wires coming out of the harness near the coil. Two go to a
> "T" shaped plug that should be for the right side tail light... a black
> wire and a purple wire.
>
> Of the two remaining one is yellow and one is dark blue or black and hot
> with ignition at run. Which goes where?
>
> Now I thought the yellow wire was for the coil... and lead back to the
> plug at the firewall where the yellow wire comes up from the starter
> solenoid, but that wire is not (even at the solenoid) hot with the
> ignition at run.
>
> Based on my memory this could make sense as this could be the line that
> supplies a straight 12v shot to the coil when cranking for hotter spark...
> and that would mean both the dark blue (or black) and yellow wires go to
> the coil..... but..... then what wire connects to the single plug coming
> up from near the harmonic balancer (oil pressure?)? If both these wires
> go the coil there appear to be no wires left to connect to that plug.
>
> Ray "Grymm" Rodriguez III
> Lake Ariel, PA
> CORSA member
> 66' Corsa 140/4 coupe
> 65' Corsa 140/4 coupe (under construction and almost done!)
> 63' Monza PG coupe (under construction- quickie driver build)
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are
> the property
> of the writer, please attribute properly. For help,
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America,
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options:
> http://www.vv.corvair.org/mailman/options/virtualvairs
> _______________________________________________
>
More information about the VirtualVairs
mailing list