<VV> Torque Spec for Camaro lug nuts

[Rick Norris]

I use 80-90 Ft Lbs on all the lug nuts. I also lube the studs with a small 
amount of anti seize and re torque after putting some miles on. Of course I 
retorque the race car lugs every time!

Rick

> You guys might be a tad surprised. At bottom of linked info is a chart by
> wheel stud diameter...
>
> http://www.discounttire.com/dtcs/infoWheelTorque.dos
>
>
>
> ----- Original Message ----- 
> From: "Ian Harding" <harding.ian at gmail.com>
>
>
> On Fri, Oct 9, 2009 at 12:05 PM, Bruce Schug <bwschug at charter.net> wrote:
>>
>> On Oct 9, 2009, at 2:49 PM, Robert Marlow wrote:
>>
> <snip>
>> Have you actually built an engine without a torque wrench, Bob?
>
> I have!  It cost me a case when I pulled out a previously repaired
> stud.  Other than that, all seems to be well.... Knock on wood.  I
> only have about 500 miles on it by now.
>
> - Ian
>
>>
>>
>>
>>
>>
>> Bruce W. Schug
>
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are 
> the property
> of the writer, please attribute properly. For help, 
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: 
> http://www.vv.corvair.org/mailman/options/virtualvairs
> _______________________________________________
>