<VV> Fwd: Bell Housing torque Specs

[Mark Durham]

Clark's page Tech-5 shows 20-30 ft lbs.

Auto's use washers under all bolts, sticks have a special pattern with some
washers, some not, , see page tech-10A

Mark Durham


On Mon, Nov 30, 2009 at 4:52 PM, Matt Nall <patiomatt at aol.com> wrote:

>
>
>
>
>
> -----Original Message-----
> From: Duane%20 <duane.mclaughlin at comcast.net>
> To: vv-help at corvair.org
> Sent: Mon, Nov 30, 2009 4:46 pm
> Subject: Bell Housing torque Specs
>
>
>
>
> Looking through a Corvair shop manual, I can't seem to find an entry on the
> Engine Component Torques page for the Bell Housing.
> What is the torque supposed to be for the bell housing to the crankcase?
>
> Thanks!
>
>
>  _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are
> the property
> of the writer, please attribute properly. For help, mailto:
> vv-help at corvair.org
> This list sponsored by the Corvair Society of America,
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options:
> http://www.vv.corvair.org/mailman/options/virtualvairs
>  _______________________________________________
>