<VV> Wiring the relay to the inertia shutoff switch

[Harry Yarnell]

Is this the standard Bosch relay?
Way I'd wire it would be one side of the inertia switch to +, other side to 
85.
Ground 86.
87 to +.
30 to pump.
Other side of pump to ground.

Harry Yarnell
Perryman garage and orphanage
Perryman, MD
hyarnell1 at earthlink.net
----- Original Message ----- 
From: "Stephen Upham" <contactsmu at sbcglobal.net>
To: "Virtual Vairs" <virtualvairs at corvair.org>
Sent: Sunday, May 17, 2009 12:08 PM
Subject: <VV> Wiring the relay to the inertia shutoff switch


>I got my relay hooked up and the pump is running.  When I tried to
> attach the inertia switch, I could not get the right series of
> connections in the right order to get it to operate.  I have checked
> the switch with a circuit tester and it does function properly.  I
> connected the harness wire and the positive of the inertia to (85) on
> the relay and grounded the inertia to the body.  No pump.   I then
> tried to combine the inertia ground and the relay ground (86) on the
> relay, but again, no pump.
>
> What am I doing wrong?
>
> Stephen U
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are 
> the property
> of the writer, please attribute properly. For help, 
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: 
> http://www.vv.corvair.org/mailman/options/virtualvairs
> _______________________________________________
>