<VV> Oil Pump Idler gear removal

[jvhroberts at aol.com]

 Put the housing in an oven at about 300 degrees. Aluminum expands more than steel, and this should make it a lot easier to drive out. Make sure you remove it while it's hot!





 





 



-----Original Message-----

From: RWhitt1245 at aol.com

To: virtualvairs at corvair.org

Sent: Sun, 17 May 2009 9:24 am

Subject: <VV> Oil Pump Idler gear removal













Can anyone tell me an easy way to remove this from the housing? I had one  

come out fairly easy with hammer and punch, but I have another that is being 

 difficult.

 

Thanks

Ron

**************A strong credit score is 700 or above.  See Yours in Just 2 

Easy Steps! 

(http://pr.atwola.com/promoclk/100126575x1222585011x1201462751/aol?redir=http://www.freecreditreport.com/pm/default.aspx?sc=668072&hmpgID=115&

bcd=Maystrongfooter51709NO115)

 _______________________________________________

This message was sent by the VirtualVairs mailing list, all copyrights are the 

property

of the writer, please attribute properly. For help, mailto:vv-help at corvair.org

This list sponsored by the Corvair Society of America, http://www.corvair.org/

Post messages to: VirtualVairs at corvair.org

Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs 

 _______________________________________________