<VV> removing engine shrouds

[Harry Yarnell]

There's a 9/16" hex head bolt INSIDE the 4" hose hole. Remove the snout 
(5/16), remove the bolt and the one outside, and wiggle the shroud out.

Harry Yarnell
Perryman garage and orphanage
Perryman, MD
hyarnell1 at earthlink.net
----- Original Message ----- 
From: "chris mann" <cfmann at yahoo.com>
To: "Virtual Vairs" <virtualvairs at corvair.org>
Sent: Wednesday, March 18, 2009 8:28 AM
Subject: <VV> removing engine shrouds


>I have removed most all the shrouds around my 110 to have cleaned and 
>powder coated. And have two left to remove yet. These are the two are on 
>each side of the bell housing and connect to the air blower motor with two 
>flexible 4" hoses. I am scratching my head as to how to get these off. Do I 
>have to separate the motor from the bell housing to take them off?
> -chris
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are 
> the property
> of the writer, please attribute properly. For help, 
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: 
> http://www.vv.corvair.org/mailman/options/virtualvairs
> _______________________________________________
>