<VV> Disconnecting the wiring harness

[HallGrenn at aol.com]

In a message dated 3/6/2009 8:14:32 P.M. Eastern Standard Time,  
contactsmu at sbcglobal.net writes:

There is  very little room to work in (can just manage  
to get two hands on it)  and I have tried for the last twenty minutes  
to get it disconnected  with no luck.  It doesn't budge a bit, and I  
really don't want  to tug on it any more than absolutely necessary.    
Ideas?

Stephen
_______________________________________________


If you have some wood chips jammed into the tines to keep them from  
re-attaching you can spend your time and both hands to rock side to side and up  and 
down until on side or the other gives, then just keep rocking.  I've  done it 
on several LMs but only done the rear engine bay junction on a FC so I  don't 
have much EM experience.  Don't worry too much if you pull a few  wires out; 
you can re-anchor them in the junction block later with a little care  if you 
have to.
 
Bob Hall
Group Corvair
**************A Good Credit Score is 700 or Above. See yours in just 2 easy 
steps! 
(http://pr.atwola.com/promoclk/100126575x1219957551x1201325337/aol?redir=http:%2F%2Fwww.freecreditreport.com%2Fpm%2Fdefault.aspx%3Fsc%3D668072%26hmpgID
%3D62%26bcd%3DfebemailfooterNO62)