<VV> LM Radio Antenna Hole Location

[John O'Shea]

Thanks for the help Ron.
That location seems to be about where the template shown in the Accessories 
Instructions
would place the hole, but as I mentioned, there are no measurements with 
those instructions.
Thanks again.

----- Original Message ----- 
From: "Ron" <ronh at owt.com>
To: "John O'Shea" <jco99 at cox.net>
Sent: Thursday, July 09, 2009 2:37 PM
Subject: Re: <VV> LM Radio Antenna Hole Location


> Per my '66, the hole center is 1 1/2 inches from the side edge of the hood 
> opening and 1 inch forward from the RR corner of the hood.  I do believe 
> that the antenna was dealer installed.
> RonH
>
> ----- Original Message ----- 
> From: "John O'Shea" <jco99 at cox.net>
> To: "Virtual Vairs" <virtualvairs at corvair.org>
> Sent: Thursday, July 09, 2009 1:48 PM
> Subject: <VV> LM Radio Antenna Hole Location
>
>
>>I need to install a GM type radio antenna in the passenger front fender of 
>>a LM.
>>
>> I went to my "Chevrolet Corvair Installation Instructions - Options and 
>> Accessories" where the antenna installation is described with pictures. 
>> Unfortunately the fender hole location is not provided.  Instead, the 
>> instructions call for use of a hole locating template.
>> Forty four years ago those templates were probably everywhere.  Today 
>> it's not so easy to find One.
>>
>> Can anyone give me the stock hole location referenced off the rear corner 
>> of the trunk lid, or any reference that seems appropriate.
>>
>> Thanks for your help.
>> _______________________________________________
>> This message was sent by the VirtualVairs mailing list, all copyrights 
>> are the property
>> of the writer, please attribute properly. For help, 
>> mailto:vv-help at corvair.org
>> This list sponsored by the Corvair Society of America, 
>> http://www.corvair.org/
>> Post messages to: VirtualVairs at corvair.org
>> Change your options: 
>> http://www.vv.corvair.org/mailman/options/virtualvairs
>> _______________________________________________
>>
>
>