<VV> Engine Problems Downunder

[Bryan Blackwell]

Usually an electronic ignition wants 12V for power, but the coil  
wants the resistor in line to drop the voltage to about 8V.  The  
resistor is not separate, it's part of the wiring harness.  You can  
splice in at the connector at the front of the engine compartment to  
get +12V.

--Bryan

On Jan 11, 2009, at 4:02 AM, smluther at optusnet.com.au wrote:

> Anyway, my technician was wondering whether the voltage on the  
> ignition
> should change from 12V to 6 V due to the resistor connection? (or  
> should it remain at 12 V?)
> Is this supposed to happen?  What should / could be  checked to  
> eliminate this fluttering effect?