<VV> stripped V.C. bolt threads

[shortle]

A good place to get the "books" is e(vil) bay so long as you don't mind second hand.Or if you must have new, try the vendors. Hope this helps.
Timothy Shortle in (beautiful) Durango Colorado 

-----Original Message-----
>From: dave ross <dave_r505 at yahoo.com>
>Sent: Feb 12, 2009 10:47 AM
>To: virtualvairs at corvair.org
>Subject: <VV> stripped V.C. bolt threads
>
>Ok guys here's my new predicament.. I used every ones awesome advice and located, adjusted the lifter in question! Thanks again! While I was tightening a vc bolt, you guessed it, I stripped the threads out... I hardly applied any torque at all so I know it was ready to go. I've heard a lot of different suggestions but none from a Corvair enthusiast.(Which I find myself quickly becoming) So any advise would be much appreciated! I apologize if this is covered in the manual, I had some responses to just look in the manual and if I had one, I assure you I would! Mabey I can buy one from someone?!? ha
>
>Dave
>
>
>      
> _______________________________________________
>This message was sent by the VirtualVairs mailing list, all copyrights are the property
>of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
>This list sponsored by the Corvair Society of America, http://www.corvair.org/
>Post messages to: VirtualVairs at corvair.org
>Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs 
> _______________________________________________