<VV> Need Headlight Buckets for 67 Coupe

[airvair at earthlink.net]

Mike,

The LM headlight buckets all come out the same way. There's a series of
small hex headed fasteners around the perimeter that you take out. Then
simply break the body sealant holding them in. BTW, this is the way you
"break" into the trunk if you don't have a key or the lock gets jammed.

As to interchangability, I think there are only two variations (would have
to check to make sure, though). The early '65's used buckets that attached
the bezel to the headlight backing plate. A second design came along late
in the model year that attached the bezel to the bucket itself, and was the
same design thru to the end of '69.

-Mark


> [Original Message]
> From: <mikeamauro at aol.com>
> Subject: <VV> Need Headlight Buckets for 67 Coupe
>
> Mine are rusted and allowing water into the trunk. NOS (good luck) or
good  
> used. Any for sale? Apparently not all lates are the same; "me thinks" I 
> would  need ones from a 67, 68, or 69 model year. Would also appreciate
some 
> advice on  what it takes to change them out.
>  
> Thanks,
>  
> Mike Mauro
> 67 Factory Air, PG, Coupe
>  
>  
>  _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights
are the property
> of the writer, please attribute properly. For help,
mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America,
http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options:
http://www.vv.corvair.org/mailman/options/virtualvairs 
>  _______________________________________________