<VV> Blower Fan Bearing
Dennis Pleau
dpleau at wavecable.com
Mon Aug 31 22:15:41 EDT 2009
It's called a ruler. Measure the height of the current bearing, install the
new bearing to the same height.
dp
-----Original Message-----
From: Ron [mailto:ronh at owt.com]
Sent: Monday, August 31, 2009 6:19 PM
To: Dennis Pleau; 'Dale Allen'; virtualvairs at corvair.org
Subject: Re: <VV> Blower Fan Bearing
It also requires some sort of a setup to measure and control the height of
the bearing assembly being installed.
RonH
----- Original Message -----
From: "Dennis Pleau" <dpleau at wavecable.com>
To: "'Dale Allen'" <AusBallooningFed at bigpond.com>;
<virtualvairs at corvair.org>
Sent: Monday, August 31, 2009 6:07 PM
Subject: Re: <VV> Blower Fan Bearing
> Look for an original type bearing like Clark's bare bearing that already
> has
> the casting that holds the fan pressed on. I'm sure Clark's has one or
> the
> Underground or Larry. Or a lot of other vendors. To remove the old one
> and
> replace the new in the top cover on only takes a propane torch. I would
> replace the top cover gaskets and think about changing the gaskets under
> the
> carbs as they will have to be R&Red.
More information about the VirtualVairs
mailing list