<VV> Head gasket installation

[Beamin Scott]

You are correct, flat side to head and raised side to jug.

On Sat, Aug 15, 2009 at 10:14 AM, <mwclarke01 at gmail.com> wrote:

> Can someone please confirm for me which direction the head gaskets should
> be installed?  There is a smooth side and a raised side on the stainless
> steel gaskets that I purchased.  Logically it would seem that the smooth
> side should fit down into the head and the raised side would go against the
> jug.  Just want to make sure I get this right.
>
> Thanks for the help.
>
> Mark C.
> Sugar Land, Tx
> Corvair Houston
> '63 Monza Convertible
> Sent via BlackBerry by AT&T
>  _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are
> the property
> of the writer, please attribute properly. For help, mailto:
> vv-help at corvair.org
> This list sponsored by the Corvair Society of America,
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options:
> http://www.vv.corvair.org/mailman/options/virtualvairs
>  _______________________________________________
>