<VV> Idler Pulley bolt...

[Ron]

The coupler nuts can also be found in the needed fine thread, I have them on 
my cars.
RonH

----- Original Message ----- 
From: "Bryan Blackwell" <bryan at skiblack.com>
To: "Secular" <rusecular at yahoo.com>
Cc: <virtualvairs at corvair.org>
Sent: Monday, September 15, 2008 5:16 PM
Subject: Re: <VV> Idler Pulley bolt...


> Do you mean the longer nut?  With the "bentwrench" you should be able
> to get at both of them pretty well.  I tried the couplers, and the
> problem with the ones I had was because they were 1/2", so I needed
> two wrenches.  Using two studs and the nuts sounds like a better
> option than just one.  The coupler nuts are 3/8" SAE coarse.
>
> --Bryan
>
> On Sep 15, 2008, at 5:17 PM, Secular wrote:
>
>>  Could someone kindly post the size (and length) of the longer bolt
>> which
>>   would replace the current one under the idler pulley.
>>
>>   I know removing the dist. cap makes loosening this bolt quite
>> easy, I also
>>   have the special wrench (c3773 from Clark's).
>
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are 
> the property
> of the writer, please attribute properly. For help, 
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: 
> http://www.vv.corvair.org/mailman/options/virtualvairs
> _______________________________________________
>
>