<VV> Syncing the carbs on 110 / Mileage problem

[PatioMatt at aol.com]

Stephan....you engine is already running / driving...
 
Get it warmed up
 
Remove air filter assy.   
 
Disconnect drivers side linkage
 
put Unisyn on left carb....
 
turn thumbscrew to get ball near a center line....not critical!
 
Without touching anything...  lift Unisyn off of left carb and place  on 
right side...is ball in SAME place?
 
#2  SO  you've got an oilbath....   ???    Take it off... will add 2-5 
mpg....  Streets are PAVED!!  you  certainly do not need it!
 
 
 
 
 
 
Matt  Nall
Sea Mountain
Charleston, Ore.
_http://members.aol.com/patiomatt  

 
In a message dated 6/24/2008 5:58:20 P.M. Pacific Standard Time,  
contactsmu at sbcglobal.net writes:

Ok, got  to the part on syncing the carbs where I'm using a piece of  
paper as  a feeler gauge on the right carb idle screw.  I put the  
paper  in, got it taunt - not tight, and tried to screw in the idle  
screw 1  1/2 turns (clockwise) per the Basics book.  If that means 540   
degrees (and clockwise) it ain't happening.  The screw stops at  360.   
And now....???

Stephen  Upham
_______________________________________________
This message was  sent by the VirtualVairs mailing list, all copyrights are 
the property
of  the writer, please attribute properly. For help,  
mailto:vv-help at corvair.org
This list sponsored by the Corvair Society of  America, 
http://www.corvair.org/
Post messages to:  VirtualVairs at corvair.org
Change your options:  http://www.vv.corvair.org/mailman/options/virtualvairs  
_______________________________________________


_ (http://members.aol.com/patiomatt) 



**************Gas prices getting you down? Search AOL Autos for 
fuel-efficient used cars.      (http://autos.aol.com/used?ncid=aolaut00050000000007)