<VV> torque converter

[Harry Yarnell]

Remove the front engine shroud, and you will see a small (3") plate that 
covers a hole in the bell housing. Remove the plate and check all three 
torque converter bolts.

Harry Yarnell
Perryman garage and orphanage
Perryman, MD
hyarnell1 at earthlink.net
----- Original Message ----- 
From: <sharpiebandit06 at bellsouth.net>
To: "Vair Club" <VirtualVairs at corvair.org>
Sent: Thursday, June 05, 2008 2:52 PM
Subject: <VV> torque converter


> Hey all,
>   I've got some severe vibrating going on when my PG is in drive or 
> reverse, but not in neutral. One guy who does corvair told me to check the 
> bolts that anchor the torque converter through the inspection plate. Where 
> is this plate?
>
> Charles   6/5/08
> '65 Monza 115hp
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are 
> the property
> of the writer, please attribute properly. For help, 
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: 
> http://www.vv.corvair.org/mailman/options/virtualvairs
> _______________________________________________
>