<VV> Website updates

[Mark Edmonds]

Nice photos etc.  What is the function of the 5/16" allen head set screw
shown on the side of the carb intake in one of the photos?
ME

-----Original Message-----
From: virtualvairs-bounces at corvair.org
[mailto:virtualvairs-bounces at corvair.org] On Behalf Of Bryan Blackwell
Sent: Friday, July 18, 2008 9:51 PM
To: Virtual Vairs
Cc: Northern Va Corvair Club
Subject: <VV> Website updates

As some of you may have noticed, the demands on my time have  
slackened a bit, so I got a couple of new pages up.  First is  
courtesy of Rick Norris, he installed one of the Otto Parts carb  
rotator kits on his track car, and did a great job documenting it:

http://autoxer.skiblack.com/OttoRotator/ottoRotatorNorris.html

Next is an expansion of the post I made regarding engine break in, I  
added some more based on feedback and a little further reading:

http://autoxer.skiblack.com/break-in.html

I should add that a couple of engine builders have suggested a  
similar procedure, they just didn't lay it out in quite so much  
detail - one summed it up simply "Build 'em right, wind 'em tight".

Comments or questions welcome.

Bryan Blackwell bryan at skiblack.com
http://autoxer.skiblack.com/
   Corvairs: '61 Lakewood, '64 Greenbrier, '65 Corsa, '66 Corsa
   '69 Road Runner, '97 Ford F-150, '99 Neon R/T
"Why do something if you're not going to obsess about it?"


 _______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are
the property
of the writer, please attribute properly. For help,
mailto:vv-help at corvair.org
This list sponsored by the Corvair Society of America,
http://www.corvair.org/
Post messages to: VirtualVairs at corvair.org
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs 
 _______________________________________________