<VV> Front suspension questions.

[Brandes, Guy]

Hi All,

If you're checking at the tire you should take into account any
excessive play in the wheel bearings.

Regards,

Guy Brandes

65 VAIR 140
Yes, at the tire.

Thanks.


Harry Yarnell wrote:
> See interdispersed comments:
>
> harry yarnell
> perryman garage and orphanage
> hyarnell1 at earthlink.net
> ----- Original Message ----- From: "chris c" <ricorvair at cox.net>
> To: "VirtualVairs AA" <VirtualVairs at corvair.org>
> Sent: Monday, February 04, 2008 9:54 AM
> Subject: <VV> Front suspension questions.
>
>
>> I replaced the passanger side ball joints.
>>
>> 0.  Do you need to grease new ball joints.  It looked like grease was
>> allready in them.
>
> I would...
>
>>
>> 1.  I removed the stabilizer bar (sealing the gas tank).  Is it ok to
>> drive the car around the block without the bar.
>
> Yes
>>
>> 2. How much play is normal on the tie rods.  Very slight movement
(about
>> 1/4 inch) if I try to rock either tire.  When I had everything apart
the
>> tie rod ends were not stiff (but could nots shift in and out of
joint).
>
> I assume you mean 1/4" at the edge of the tire. That's borderline. 
> There are a lot of joints in the steering linkage; 4 tie rod ends, 
> idler, and Pitman bushing, plus the box itself. All can create play...
>
>
>
>


 _______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights
are the property
of the writer, please attribute properly. For help,
mailto:vv-help at corvair.org
This list sponsored by the Corvair Society of America,
http://www.corvair.org/
Post messages to: VirtualVairs at corvair.org
Change your options:
http://www.vv.corvair.org/mailman/options/virtualvairs 
 _______________________________________________