<VV> Heater shroud followup

[Western Canada CORSA]

Rod,

That 1" hole is for a road draft tube, which is the early PCV system used on
Corvairs.  It's a '61-2 system, which means your engine is probably a 98hp

Regards,
Joel

-----Original Message-----
From: virtualvairs-bounces at corvair.org
[mailto:virtualvairs-bounces at corvair.org] On Behalf Of Rod Murray
Sent: Wednesday, December 24, 2008 8:07 AM
To: 'virtualvairs at corvair.org'
Subject: <VV> Heater shroud followup


Thx for responses...long story short, I attempted removal yesterday - All
bolts came off easily except at rear damper door area. couldn't figure out
how to remove so ended up putting everything back for now. Someone suggested
I keep removing bolts til shrouds come out but I'd rather have something
resembling an actual strategy. I hv shop and assembly manuals - does anyone
know what page(s) cover the lower shrouds?  I couldn't find it.

Also, the muffler side lower shroud has a 1" pre-cut hole on bottom sheet
metal - looks factory. Any ideas what this is for?  My 164 shrouds don't hv
this and seems like I'd be losing heat out this hole.

Thx
Rod
64 brier w non-original "ZK" engine (meaning 145 98 or 102 hp).

Happy holidays!
------------------------
Thx, Rod
(BlackBerry built - pls excuse typos)
_______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are
the property of the writer, please attribute properly. For help,
mailto:vv-help at corvair.org This list sponsored by the Corvair Society of
America, http://www.corvair.org/ Post messages to: VirtualVairs at corvair.org
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs 
 _______________________________________________