<VV> Hydraulic clutch, anyone done one?

[Joe Robbins]

Sounds like a good question for Fastvair.
http://groups.yahoo.com/group/fastvair


Joe Robbins
BBRT



-----Original Message-----
From: virtualvairs-bounces at corvair.org
[mailto:virtualvairs-bounces at corvair.org] On Behalf Of WSan159401 at aol.com
Sent: Saturday, August 02, 2008 11:13 AM
To: virtualvairs at corvair.org
Subject: <VV> Hydraulic clutch, anyone done one?

I am looking for help to install a hydraulic clutch in my racer. I have  
mounted a Wilwood master cylinder and a Wilwood pull type slave cylinder at
the  
rear of the car in place of the stock pull rod. The throw out arm and
bearing  
are stock Corvair. Will this work? Or can an aftermarket hydraulic throw out

bearing assembly be adapted to work? Please reply with any solutions that
you  
may have for this application, thanks for the help.
Bill Sanders
Yenko Stinger YS-005
1965 Corsa coupe
1965 Ex-SCCA D/P, GT-3 racer (car in question)
 
 



**************Looking for a car that's sporty, fun and fits in your budget? 
Read reviews on AOL Autos.      
(http://autos.aol.com/cars-BMW-128-2008/expert-review?ncid=aolaut00050000000
017 )
 _______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are
the property
of the writer, please attribute properly. For help,
mailto:vv-help at corvair.org
This list sponsored by the Corvair Society of America,
http://www.corvair.org/
Post messages to: VirtualVairs at corvair.org
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs 
 _______________________________________________