<VV> Master Cylinder

[Bryan Blackwell]

The last time I did this, I just mounted it in the car and "bench  
bled" it before connecting the lines.  Seemed to work ok, and I  
didn't have to carry around a master cylinder full of fluid.

--Bryan

On Sep 16, 2007, at 9:37 PM, Bill Elliott wrote:

> Basically what you're doing is getting all of the air out of the  
> master before mounting it. You connect hose(s) from the master  
> output and place them in the reservoir. (Many new masters come with  
> plastic fittings and hoses just to do this...)
>
> Fill the reservoir with fluid then slowly compress the master while  
> holding it horizontal. Then release. Keep doing this until air  
> bubbles cease coming out of the end of the hose(s) on compression.  
> Easiest to do in a vise.