<VV> Hints to remove LM kick-panel?

[Ron]

Nice, but where are these heaps of convertible vent stacks?
RonH

----- Original Message ----- 
From: "Mark Corbin" <airvair at earthlink.net>
To: "J R Read_HML" <hmlinc at sbcglobal.net>; <virtualvairs at corvair.org>; "Jeff 
Wilson" <jwilson at unctv.org>
Sent: Tuesday, October 16, 2007 4:19 PM
Subject: Re: <VV> Hints to remove LM kick-panel?


> Then you could follow the tech tip in the CORSA Tech Guide about replacing
> them with convertable vent stacks. No more gobs of messy gray dum-dum, or
> worrying if you have stuffed enough of it back in to prevent a water 
> leak..
>
> -Mark
>
>
>> [Original Message]
>> From: J R Read_HML <hmlinc at sbcglobal.net>
>> Subject: Re: <VV> Hints to remove LM kick-panel?
>>
>> Only the convertibles have the 2 piece kick panel unless someone has
> moved
>> one over.  So, you just have to deal with pry, wiggle, pull, whatever.
> It
>> is somewhat pliable and should not break.
>>
>> Later, JR
>>
>> ----- Original Message ----- 
>> From: "Jeff Wilson" <jwilson at unctv.org>
>> Subject: <VV> Hints to remove LM kick-panel?
>>
>> > Anyone have any helpful hints/ tips on removing the kick-panel on a
>> > 65 '500' series?
>> >
>> > Seems to be a single-piece plastic part.
>> >
>> > I want to vacuum-out the accumulated crud down in my fresh-air vents.
>> >
>> > CJ Wilso
>
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are 
> the property
> of the writer, please attribute properly. For help, 
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: 
> http://www.vv.corvair.org/mailman/options/virtualvairs
> _______________________________________________
>