<VV> Oilpan bolt length?

[kcvair at netscape.com]

Andy-Screw 1 in to be sure it doesn't bottom out.  That should tell you if it's too long.  I think I've used some in the past when the holding ability of the 3/4 wasn't too good.  Ken Clark

KCVAIR
66 CORSA CN W/AIR
65 CORSA CP

--- akinzelm at greatnortherncorp.com wrote:

From: "Kinzelman, Andy" <akinzelm at greatnortherncorp.com>
To: <virtualvairs at corvair.org>
Subject: <VV> Oilpan bolt length?
Date: Fri, 30 Nov 2007 08:16:09 -0600

Quick question - can I use 1" long bolts for the stock oilpan with cork gasket - or should I go with ¾"?
Thanks,
Andy K.
 _______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are the property
of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
This list sponsored by the Corvair Society of America, http://www.corvair.org/
Post messages to: VirtualVairs at corvair.org
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
 _______________________________________________




_____________________________________________________________
Netscape.  Just the Net You Need.