<VV> New Clutch Isnt Working
Shaun McGarvey
shaun_mcgarvey at shaw.ca
Mon Nov 26 15:08:16 EST 2007
It's worth a try, but I doubt it...
----- Original Message -----
From: "Lon Wall" <corvairs at pacifier.com>
To: "Shaun McGarvey" <shaun_mcgarvey at shaw.ca>
Cc: <virtualvairs at corvair.org>
Sent: Monday, November 26, 2007 9:50 AM
Subject: Re: <VV> New Clutch Isnt Working
> Shaun - If it IS the bushing (and his symptons are right in that
> direction) then PLEASE do not waste your time by dropping the
> powertrain! It WILL get better, and in a fairly short amount of time. Lon
>
> Shaun McGarvey wrote:
>
>> It IS the bushing, Steve.
>> When installed, they mushroom slightly, closing up the inner diameter
>> just at the end where you hammer on.
>> When I install them, as a last thing, I pull out the stub shaft I use
>> to drive them, most of the way out and then wallow out the end
>> slightly to restore the proper hole size, checking with the input
>> shaft for no tightness.
>> I think you'll need to pull the engine again. I doubt it'll get better.
>>
>> yea, Vairily ... Shaun
>
>
More information about the VirtualVairs
mailing list