<VV> Adaptor

[Bob Gilbert]

Many years ago I drilled a 110HP head for a thermister and drilled right into the head gasket sealing area.. On that head the hole location was closer to the block than on the 140HP head I had.

Bob
  ----- Original Message ----- 
  From: JVHRoberts at aol.com 
  To: traceya at montrose.net ; virtualVairs at corvair.org ; fastvair at yahoogroups.com ; ppcc-list at corvair.org 
  Sent: Thursday, November 22, 2007 10:38 AM
  Subject: Re: <VV> Adaptor


  Whenever I've done it, I simply drill the hole deeper and run a fine thread tap over the coarse threads. Not kosher, but I've never had a problem either. And no parts to make!

  In a message dated 11/22/2007 11:40:32 A.M. Eastern Standard Time, traceya at montrose.net writes:
    I need an adaptor to put a thermister for a Corsa dash in a snap sender hole. Just the specs would enable me to make one.

    Thanks,
    Bob






------------------------------------------------------------------------------
  Check out AOL Money & Finance's list of the hottest products and top money wasters of 2007.


------------------------------------------------------------------------------


  No virus found in this incoming message.
  Checked by AVG Free Edition. 
  Version: 7.5.503 / Virus Database: 269.16.1/1141 - Release Date: 11/20/2007 11:34 AM