<VV> cylinder heads for reliability
J R Read_HML
hmlinc at sbcglobal.net
Sun Nov 11 21:52:33 EST 2007
I would NOT use the 140.
Later, JR
----- Original Message -----
From: "shortle" <shortle556 at earthlink.net>
To: <virtualvairs at corvair.org>
Sent: Sunday, November 11, 2007 8:09 PM
Subject: <VV> cylinder heads for reliability
>A question for the crowd: Which cylinder heads should be used for the most
>reliability? I just lost an intake valve seat on my 1963 Rampside 140HP PG.
>These heads were VERY deflashed.I have OTTO valve covers and oil pan.I am
>using a 12 plate cooler with both side plates. And it was 38 degrees at
>5:00 AM in SW Colorado. My 3 choices are:1965 95HP heads, 1969 95HP heads
>(flat combustion chamber), or another 140HP. I am most in need of
>reliability and not performance or excessive use of the truck as a
>worktruck.Anyone?
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are
> the property
> of the writer, please attribute properly. For help,
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America,
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options:
> http://www.vv.corvair.org/mailman/options/virtualvairs
> _______________________________________________
More information about the VirtualVairs
mailing list