<VV> Loose Oil Pickup Fit
Frank DuVal
corvairduval at cox.net
Mon May 28 23:45:06 EDT 2007
If you must "drive" it in after applying the RTV it will work, but if it
still a slip fit after applying the RTV, hot oil will prevent this cure
form lasting.
Tinning with solder is more permanent. If the solder melts, the engine
is running way too hot!
Frank DuVal
JVHRoberts at aol.com wrote:
>
>Being a HUGE fan of KISS, smear the outside of the tube with red RTV, drive
>it in, and forget it. End of oil suction side air leaks!
>
>
>In a message dated 5/28/2007 9:32:08 AM Eastern Daylight Time,
>harding.ian at gmail.com writes:
>
>I am putting my engine back together with a donor block and find that
>the oil pickup slips right in, and actually has a little wiggle. Last
>time I had to really push it to get it in.
>
>I am thinking I could shim it somehow, or maybe put some sealant on
>it. What's the right answer?
>
>Thanks,
>
>Ian
>
>
>
>
>
>
>************************************** See what's free at http://www.aol.com.
> _______________________________________________
>This message was sent by the VirtualVairs mailing list, all copyrights are the property
>of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
>This list sponsored by the Corvair Society of America, http://www.corvair.org/
>Post messages to: VirtualVairs at corvair.org
>Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
> _______________________________________________
>
>
>
More information about the VirtualVairs
mailing list