<VV> Loose Oil Pickup Fit

[Jack Kean]

Not to preach (because I overlook information in my shop manual all of the time), but this is what is called out in the shop manual (1965 version: page 6-49): "before installation of oil pump screen and tube, the end of the tube (on the outside diameter) must be tinned".

mine fell out of the case half when I removed the bolt. That got my attention. I replaced it with a extended pickup for the Otto parts pan that I am using. 

jack kean

----- Original Message ----
From: "BobHelt at aol.com" <BobHelt at aol.com>
To: harding.ian at gmail.com; virtualvairs at corvair.org
Sent: Monday, May 28, 2007 12:12:19 PM
Subject: Re: <VV> Loose Oil Pickup Fit

 
In a message dated 5/28/2007 6:44:54 AM US Mountain Standard Time,  
harding.ian at gmail.com writes:

Hey, me,  I have an idea, maybe I could tin it with some  solder....



Of course!
Regards,
Bob Helt



************************************** See what's free at http://www.aol.com.
 _______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are the property
of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
This list sponsored by the Corvair Society of America, http://www.corvair.org/
Post messages to: VirtualVairs at corvair.org
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs 
 _______________________________________________