<VV> RE: directional sw

[Frank DuVal]

Don't forget the snap ring at the steering wheel bearing.

Frank DuVal

Craig Nicol wrote:

>Hank asked:
>
>Pulled the wheel this AM. And the directional plate (the piece that the
>screw for the end of the lever screws into) was cracked.
> 
>Question: I got out the phillips screw that holds the canceller plate, but
>the other piece of the arm  in the switch is still in there somehow, looks
>like a rubber bushing of some type.  Do you have to take the whole switch
>out of the column to remove/replace the canceller arm?   
>
>I've only done this once before (20 years ago) and I replaced the whole
>switch that time, so I don't know how to proceed.
>
>Any ideas? <unsnip>
>
>Craig sez
>Unplug the connectors at the base of the column and take out the three
>screws that hold the switch.  Pull the switch out as much as you can and
>flip it over. The retaining screw is on the back of the switch.
>Craig
>
> _______________________________________________
>This message was sent by the VirtualVairs mailing list, all copyrights are the property
>of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
>This list sponsored by the Corvair Society of America, http://www.corvair.org/
>Post messages to: VirtualVairs at corvair.org
>Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs 
> _______________________________________________
>
>  
>