<VV> Electric fuel pump wiring...

[AeroNed at aol.com]

In a message dated 3/28/2007 9:04:36 P.M. Central Daylight Time,  
TimogensTurbo at aol.com writes:

Just  connect to the Junction stud in the engine compartment [ dreaded RED  
platic thingy]  with a Fuse.....

Then it's automatic.....no  engine running [ no pressure]  no fuel pump[

Cold starts are a  breeze....a few seconds to get oil pressure and away you  
go....




With this wiring setup the pump will still run for about 10 seconds or so  
after you turn off the ignition. That would be OK if there's no fuel leak and  
the carb valves are good. I tapped into the ignition wire off the big harness 
to  activate a relay. The relay controls the negative feed from the "Horrid 
Plastic  Thingy". Ground is through the Vega OP switch. The fuel pump runs while 
the  ignition switch is on and there's oil pressure.
 
Ned



************************************** See what's free at http://www.aol.com.