<VV> choke or pull-off problem

[J R Read_HML]

Try gently mashing the pedal to the floor ONE time and releasing gently. 
That should set the chokes.
Later, JR

----- Original Message ----- 
From: "Dennis Dorogi" <dfamily at fairpoint.net>
To: <virtualvairs at corvair.org>
Sent: Tuesday, June 05, 2007 11:45 AM
Subject: <VV> choke or pull-off problem


My 65 monza 110 will start OK after setting for a week or so.  I have to 
pump the accelerator pedal 6 or 7 times and it will start and run smoothly 
on fast idle for about  for about 5-7 seconds and then just quit. It doesn't 
run rough or anything - it just dies and has been flooded out.  It is 
difficult to restart until the gas has cleared.
      My questions are:  Do I have the chokes adjusted improperly or is it a 
choke pull off problem?  Choke pull-offs are new and working.  What is a 
good setting for the choke unloader adjustment?  The recommended setting 
doesn't seem to open the chokes enough for an easy restart after being 
flooded.   Thank you for your help. Dennis Dorogi
 _______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are 
the property
of the writer, please attribute properly. For help, 
mailto:vv-help at corvair.org
This list sponsored by the Corvair Society of America, 
http://www.corvair.org/
Post messages to: VirtualVairs at corvair.org
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
 _______________________________________________


-- 
No virus found in this incoming message.
Checked by AVG Free Edition.
Version: 7.5.472 / Virus Database: 269.8.9/832 - Release Date: 6/4/2007 6:43 
PM