<VV> removal tool - second try

[Sethracer at aol.com]

If you  put a little silicone rubber on the tips of the needle noise you
will avoid  scratching the bezel.

Regards,Guy Brandes




Thanks Guy. The part I am trying to tighten down is the round nut below the  
bezel. The bezel screws down onto it, after the cluster is installed. Like  
others have suggested, I have used a pair of screwdrivers as a tool to remove  
the bezel, but the needle nose would also do the trick. With a little bit of  
modification, I should be able to take a cheap pair of crappy small needlenose  
pliers and make them into a tool to remove the round nut underneath.  - Seth




************************************** Get a sneak peek of the all-new AOL at 
http://discover.aol.com/memed/aolcom30tour