<VV> Light switch removal tool - wanted

[Sethracer at aol.com]

The Corvair headlight switch is attached (on the late model, at least) by a  
round trim nut, threaded externally on the front to screw into the switch and 
on  the back to allow a trim piece/bezel to screw down over it. I believe the 
round  trim nut is tightened down by engaging it with a special tool that has 
a pair of  pins sticking out to slide into the matching pair of holes in the 
round  trim nut. There is no hex to use with a wrench, just the round  
surfaces. Does anyone make that tool? Or know where one might be available? I  had to 
shift the headlight switch location slightly to clear the roll cage  tubing. 
The hole has been trimmed to allow the switch location, but I don't have  
exactly the right tool to tighten the nut. I know I can just screw on the trim  
piece/bezel and tighten it with a huge screwdriver, but I thought I would see if  
anybody had the correct tool. - Seth Emerson 



************************************** Get a sneak peek of the all-new AOL at 
http://discover.aol.com/memed/aolcom30tour