<VV> PG adjustment nightmare

[Harry Yarnell]

The groove is for an O ring seal.
The lateral travel of the TV shaft is controlled by the internal link. It's 
spline to go on only one way and is held in place by a pinch bolt (5/16 hex 
head, I think). Without the O ring, the shaft will move laterally very 
easily, how much, I don't know, but it will leak ATF.

harry yarnell
perryman garage and orphanage
hyarnell1 at earthlink.net
----- Original Message ----- 
From: "Stephen Upham" <contactsmu at sbcglobal.net>
To: "Virtual Vairs" <virtualvairs at corvair.org>
Sent: Saturday, July 14, 2007 1:13 AM
Subject: <VV> PG adjustment nightmare


> Should the belhousing crank be able to move in and out of the  tranny? 
> Mine does about 3/16".  I can see a place on the bar of the  belcrank that 
> goes into the tranny that looks like a grove for an e- clip or a gasket 
> when I extend it out as far as it will go.
>
> Stephen Upham
>
>
>  _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are 
> the property
> of the writer, please attribute properly. For help, 
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: 
> http://www.vv.corvair.org/mailman/options/virtualvairs 
> _______________________________________________
>