<VV> What source for quick shift mods

[Rick Loving]

Thanks Bob, That would be the next place I would have looked, I own your
book (and nearly all other Corvair books) but sometimes it's hard to
find what you need when you have a pile of a dozen books and you know
it's in one of them.
 
Rick Loving
 
-----Original Message-----
From: BobHelt at aol.com [mailto:BobHelt at aol.com] 
Sent: Friday, July 06, 2007 3:52 PM
To: ral1963 at comcast.net; virtualvairs at corvair.org
Subject: Re: <VV> What source for quick shift mods
 
In a message dated 7/6/2007 1:34:36 PM US Mountain Standard Time,
ral1963 at comcast.net writes:
I am in the middle of a swap using a 3 speed shift tower in place of the
4 speed tower and need the measurement of how much I have to move the
1/2 ball on the shift shaft.

I would have swore it was in the Tech guide but I have thumbed through
it twice and cannot find it.

I'll be digging out the HTHRC next but would appreciate if someone knew
where the article that I am looking for was I would appreciate it...
Well, for one place, it's in my book, THE CLASSIC CORVAIR.  The distance
you move the half-ball up the shaft is 29/32 inches. Distance from the
tip of the shaft to the bottom of the ball is then 2-59/64 in.
Regards,
Bob Helt



  _____  

See what's free at AOL.com
<http://www.aol.com?ncid=AOLAOF00020000000503> .