<VV> Starting Problem

[TimogensTurbo at aol.com]

In a message dated 1/23/2007 7:02:20 PM Pacific Standard Time, 
gojoe283 at yahoo.com writes:

> One press didn't start the engine.  Two more got a
> shaky start which smoothed out just fine in about 30
> seconds...Bill H.   Brooklyn, New York
> 
==============================================

Now you're talking  with a good desription....
 Your carbs need the Idle vent tube cleared...  this is the small needle like 
brass tube in the cluster....it is swedged on the bottom and has an approx. 
0.0016" hole.....you'll need a fine wire brush strand to clear it...unles you 
are a gas welder and have tip cleaners...when held up to light....a clear 
passage..

There is also a way to do it from ontop the carb...but takes practice..and a 
long  strand!

Matt Nall...west coast
http://members.aol.com/patiomatt
lots of info!