<VV> 67-69 Boyne Directional Switch Repair

[corvairduval at cox.net]

Solder???

I never had to solder to R&I a turn signal switch. On most columns there is
a passageway to thread the connector through. On thoses that are too tight
in the passageway, just remove the pins from the plastic connector and pull
the harness through without the plastc chunk.

Frank DuVal

Original Message:
-----------------
From: Bill H. gojoe283 at yahoo.com
Date: Fri, 19 Jan 2007 08:10:13 -0800 (PST)
To: virtualvairs at corvair.org
Subject: <VV> 67-69 Boyne Directional Switch Repair


                                   B"H



The cam can then be gently pried off with the sharp
screwdriver.  Actually I removed the entire turn
signal switch; it's easier to perform the service.

Rewiring is a pain in the butt because you don't have
much room in there for new wires.  So keep the wire
lenghts to a minimum and keep the soldering very neat.

snip

--------------------------------------------------------------------
mail2web - Check your email from the web at
http://mail2web.com/ .