<VV> Flywheel bolts

[Wood, Robyn K ITC(SW)]

Ok,
	Just need to check on what I am missing here.  Was starting on
the reassembly of my '63 clutch job and noticed the flywheel bolts were
rounded a little on the edges.  Went to look at what it would cost to
replace them with a better set and I see the price is approx. $6 a bolt
from the vendors.  What is so special about these bolts?  I have not had
time to check locally, but they appear to be 11/32(?) x 1" 24NF, grade
8.  Can I dress the edges and re-install carefully or am I taking a
chance that the PO over torqued them and they could possibly fail?  Any
opinion welcome....

Thanks,
Robyn Wood

'63 Spyder Vert (almost ready for the road)
'62 Rampside






Robyn Wood, ITC
CS10/IA LCPO
USS Abraham Lincoln CVN-72
x3066/2019
wood.robyn at cvn72.navy.mil